Diablo Controls Inc. introduces the DSP-13 Series “Mag Presence Detection System”; comprised of the DSP-13M (Master) and the DSP-13S (Sensor). The DSP-13M is located in the control cabinet and the DSP-13S is placed in a single ¼ saw cut and positioned in the middle of your detection area. The detection area ranges from 3' x 3' to 15' x 15' depending upon the DSP-13M sensitivity settings found on the front panel. The DSP-13S durable epoxy encapsulation allows it to be buried in the roadbed and sealed. To protect the sensor, it is recommended that the sensor be placed 1.5 to 2.0 inches minimum below the driving surface. This will leave a protective space above the sensor for the loop sealant. When placing the sensor, please keep in mind that the orientation of the sensor is not critical as it will detect a vehicle from any direction. The size of the DSP-13S is ¼” by ¾” by 1 ½”.
 |
| (New) DSP-13 Series, Mag Presence System |
A consideration is always cost. The DSP-13 Series saves installation time, as it only requires a single cut from the edge of the roadway to the center of your detection area. The life of the roadway should increase as you can position the saw cut to be down the middle of the lane, which would be out of the tire runs.
The technology used in the DSP-13 Series incorporates 3-Dimensional processing and a patented pending communication technique over a pair of wires.
We take great pride in providing a reliable system and that’s why we provide a 5 year warranty on all of our products.
For more information, please contact Diablo Controls at 866-395-6677 and visit us at www.diablocontrols.com.
About Diablo Controls, Inc. (www.diablocontrols.com): Headquartered in Crystal Lake, IL, Diablo Controls, Inc. is a leader in the traffic, access, and parking industries. We design, manufacture, and supply a family of reliable electronic control and detection devices that can be easily installed. That’s why pros who know …. Trust Diablo!
No comments:
Post a Comment